Ask Experts Questions for FREE Help !
Ask
    jatlas's Avatar
    jatlas Posts: 3, Reputation: 1
    New Member
    		  
    #1

    Nov 22, 2011, 01:51 PM
    Dayton Garage Heater still not working after replacing Thermocoupler
    I have a dayton garage heater. The model # on the valve is v800 A 1055, Regulator V5306 A. The pilot flame goes out soon as I let go of the button. I replaced the themocoupler, And still have the same problem. Now what is the V800 bad... Thanks Joe cold in Ohio
    wmproop's Avatar
    wmproop Posts: 3,749, Reputation: 91
    Ultra Member
    		  
    #2

    Nov 23, 2011, 08:32 AM
    Are you making sure that the bulb on the end of thermocouple is in the flame of pilot while holding pilot button down and that you are holding down button long enough before letting it pop back up
    Let us know
    jatlas's Avatar
    jatlas Posts: 3, Reputation: 1
    New Member
    		  
    #3

    Nov 23, 2011, 03:54 PM
    Yes I did... jatlas
    jatlas's Avatar
    jatlas Posts: 3, Reputation: 1
    New Member
    		  
    #4

    Nov 23, 2011, 03:54 PM
    Yes I had it red hot
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Replacing a 3 wire GE furnace blower motor with a newer Dayton 4M098G multi speed mo [ 1 Answers ]

My GE furnace blower was a very simple, 5 wire installation, which the bearings wore out on. I am now truing to convert the wiring to adapt to my older furnace, and the new motor has more wires, and different color wires, and the schematic on the motor is too simple, it does not address the...

My craftsman keyless entry is only working on one garage door. Was working on both. [ 4 Answers ]

My keyless entry was working prior to vacation. We have two garage doors and each one has a different code. Only one code, and thus door, is now opening with the keyless entry pad. I replaced the battery, and that did not help. Any help is much appreciated. My garage door opener model number is...

Dayton 1RKU2 Heater is 480 volts can I change that to 220volts? [ 6 Answers ]

I have a Dayton 1RKU2 Heater that I resently purshased for a fair amount. But then when I got home I noticed it was 480 volts. I would like to know if there is a way that I could change the voltage to 220 volts, or if they make a conversion kit for this.

Dayton 1RKU2 Heater is 480 volts can I change that to 220volts? [ 1 Answers ]

I have a Dayton 1RKU2 Heater I bought it for a reasonable amount but then I went to hook up the electrical and noticed it is 480volts 3 phase. I was trying to find out if there is a way to change that to 220volt. If they make a conversion kit for this model or what would I need to do to change it?

View more questions Search