Ask Experts Questions for FREE Help !
Ask
    loweman's Avatar
    loweman Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Nov 21, 2011, 09:32 AM
    Flashing ''s'' on panel
    When I start my honda the "s" light is flashing and when I shift to d4 it won't go anywhere but when I shift to 1st to second then to third it drives all right but rough.
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
    		  
    #2

    Nov 21, 2011, 11:31 AM
    . Check for codes.

    . Change the transmission fluid and inspect the magnetic drain plug for signs of excessive wear. If the problem persists, the clutch packs may be shot and you should take it to Honda for repair.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

My clean light is flashing- is it the control panel? [ 0 Answers ]

I have an Ultra wash H/E kenmore elite dishwasher and the clean light is flashing- dishwasher will not work. Please advise.

Sub panel load size from main panel 200 amp to 100sub 350 ft [ 1 Answers ]

Wire conduit size fromm a main 200 amp panel to a 100 amp sub panel 350 ft away

Heat won't come on in auto mode error from diagnostic panel flashing 3 times [ 2 Answers ]

In January 2006 I had a new furnace installed ( a coleman gas furnace Model # BGAA070BDTBJ) and this ran fine throughout the rest of that winter. Early in the summer our thermostat went out and I installed a new Hunter thermostat # 42999 and I hooked it up as shown in the directions and it worked...

View more questions Search