Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Venting Built-In Gas Wall Ovens
[ 5 Answers ]
I am replaing an existing double gas wall oven that vents through a 5" circular metal vent to the attic and then through the roof. The old ove actually has a 5" diameter hole in the top of the oven where the metal vent connects. The new Maytag 24" double gas oven has no way to connect to the...
Question about support beam for load bearing wall
[ 1 Answers ]
We are putting a 12x24' addition on the back our our house, making a large open room that measures 22x24' (1st floor only). My contractor says we will need a support beam that will span the 24' width of the house to support the second floor and a support pole placed somewhere along that beam. He...
Is a #8 cable adequate for a 50 Amp service to double wall ovens?
[ 1 Answers ]
I am replacing 24" double wall oven with a new 30" double wall oven. I know I will have to up my 40 Amp circuit breaker to 50 Amps, but Do I have to replace the wiring too? Presently the cable to the ovens has a #8 on it for 8 gauge. Is this OK?
Electric Ovens As Compared to Gas Ovens
[ 16 Answers ]
Do electric ovens heat up faster and bake more evenly than gas ones? Just made a pizza in the electric oven where I am house-sitting for some people. Seemed like their electric oven heated up faster and did a much better job on the pizza then my gas one would do at home. The pizza was placed...
Appliance hook-up "wall unit"
[ 1 Answers ]
I have heard of a new product that is used for washer/dryer installation. It is a concave "wall" that replaces drywall. The "wall" has appropriate hook-ups for the washer and dryer venting. Purpose of the wall is to make appliances sit closer to the exterior wall, make installation easier and... View more questions Search
|