Ask Experts Questions for FREE Help !
Ask
    kevinrogers's Avatar
    kevinrogers Posts: 2, Reputation: 1
    New Member
     
    #1

    Nov 15, 2011, 02:49 PM
    Comfort Maker Furnace
    Have a comfort maker Furnace that is about 10 years old. About 1 month ago I notice a "clicking noise": while it ran. The guy cam out and said the clicking was the smart valve assembly and needed to be replaced, while replacing it he noted that there was some water in the base of the blower motor. I was told this was a design issue and that they would replace it with a kit that allows for some water to drain out of a tube that was not able to drain properly. Does this sound correct? We have the guy coming out tomorrow to make the changes to the air output pvc pipe.
    drtom4444's Avatar
    drtom4444 Posts: 3,282, Reputation: 145
    Ultra Member
     
    #2

    Nov 20, 2011, 10:13 AM
    Your coils are dirty and until you have them pulled and pressure washed you are going to have a lot of problems. You should also clean the blower wheel. 1/16" of dirt in the cups of the blades kills 30% of the efficiency. I am sure it is filthy and for him to not clean it first indicates that he is a very poor technician. DrTom4444

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Help with comfort maker rpj ii gas furnace [ 1 Answers ]

I have a comfort maker prj ii gas furnace also. What its doing is the blower will turn on, the glow ignitor will glow and as soon as the gas ignites it stay on fore about 10-15sec. And the whole heater shuts off. It repeats this every 30sec. Is the this the same problem which everyone on this...

Comfort maker rpj ii? [ 0 Answers ]

The Blower fan will not come on when the system is set for heater

Installing a Aprilaire humidifier ona comfort maker furnace [ 1 Answers ]

What parts do I need to install a Aprilaire humidifier on a Comfort Maker furnace. I been told I need a transformer, how do I wire It? Are there any diagrams available? Any help would be appriciated.

Two year old comfort maker 4 ton unit not cooling very good [ 1 Answers ]

I asked this question yesterday and was told to check pressure, I am trying to get the person that is certified who help me install the unit. He did pull a good vacuum on the unit and held it there for awhile when he installed it, but never came back to check pressure after a few days of running....

Comfort maker rpj2 [ 1 Answers ]

I need installation manual for this unit where do I find this.


View more questions Search