 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
United technologies electronic controls 1018 series?
Furnace kicks on, flame ignites and heats the exchanger up. But then the fan goes to start and all we get is a click, no spin. Motor is not frozen, you can reach in and spin the fan by hand and then it keeps spinning. Bad run capacitor or bad winding on motor? Motor was replaced 2 weeks ago.
|
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
Hired Hand heater not coming on. The UT brain is blinking twice. It was working fine off a 100pnd tank last winter. I had a large tank installed and it will not fire. It will normally kick the fan on and the igniter even when out of gas. There is no fan and the igniter is not glowing. Any ideas?
I have an S.M.C. industrial ceiling fan of type k56 (56''). It has a 5 speed control, but even on the lowest speed the fan runs far too fast. You do not feel comfortable at all in the room when it is running. I need to further reduce the speed. There are speed controls for ceiling fans at a...
Hi I downloaded the latest version of msn and basically I hate it and was wondering if anyone new how to get the 8.5.1302.1018 version of msn? I've looked but can't seem to find anywhere which works PLEASE HELP THIS NEW MSN IS CRAP XD:mad: Thanks
Are there other manufacters of remote controls to HVAC Carrier 52SE series units? The nursing home where my mother stays uses window HVAC units, but the remote control does not allow shut-off. The unit runs all the time in low or high fan mode. Is there a remote control unit that has...
View more questions Search
|
