Ask Experts Questions for FREE Help !
Ask
    slvrwngs's Avatar
    slvrwngs Posts: 2, Reputation: 1
    New Member
     
    #1

    Nov 7, 2011, 12:12 PM
    Craftsman Blower pull cord
    My cord is not broken, it just pulls straight out without any "pull" on whatever makes it start. I got online to see how to repair it, but found your question/answer site. Thought someone on here might have the answer to my problem... without my having to go buy a new blower. The blower worked fine last week, although I did have a bit of a problem with the first couple of pulls on the rope. It seemed to stick, but eventually the motor started. This week... nothing. There is no tension on the cord at all. Any suggestions?
    DG's Avatar
    DG Posts: 1,375, Reputation: 109
    Ultra Member
     
    #2

    Nov 11, 2011, 10:13 AM
    Sounds like the pawl isn't grabbing on the recoil pulley ,
    Will have to take apart and see what's up.
    Be careful and watch how you take it apart ,and put back together in reverse . Sorry but this is the I can do .
    Luck
    slvrwngs's Avatar
    slvrwngs Posts: 2, Reputation: 1
    New Member
     
    #3

    Nov 11, 2011, 10:44 AM
    Thanks! I'll try to take it apart and see why it isn't pulling.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Snowblower won't start, made bad noise using electric, pull cord now hard to pull. [ 7 Answers ]

I tried to start my snowblower today and it wouldn't start. I decided to try the electric start, plugged it in, hit the start button and all it made was a spinny grinding noise. Unplugged it, and tried to start it manually with pull cord again. The cord would not pull without lots of effort and...

Pull Cord won't pull on my Briggs and Stratton 650 Series push mower [ 5 Answers ]

Ok here goes... The pull cord is stuck. Its pulls out about 4 inches then the cord stops. Looking into the cord area ontop of mower, I notice a small white plastic piece getting caught in a notch built into the cord housing. Now... when I loosen the cord a little bit, I can slide a butter knife...

Pull cord won't pull on Murray 2.0 mower [ 7 Answers ]

I have a Murray/Briggs 6.0 engine mower and the pull cord is sticking. It will stop after pulling about 4 inches. Then if I jiggle the pull cord it will extend another 4 inches. I can see a plastic piece that seems to be stopping it at every four inches. What is causing this and what is the repair...

How to change the pull cord on a craftsman weed eater mdl#316.790101 [ 0 Answers ]

Not sure where t ostart to get at the pull cord.

I can't pull the pull cord on my lawn mower [ 2 Answers ]

I can't pull the pull cord on my briggs & straton


View more questions Search