Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Replacing Shower enclosure
[ 3 Answers ]
Hi, I had a shower enclosure made by aquaglass. The drainpan cracked because it was installed incorrectly. We are trying to find a new shower or something that would work in there. The drain is located at 7 3/4 and 7 3/4, but we are having trouble finding something. We have considered...
Shower enclosure
[ 1 Answers ]
I have a small bathroom in my house and I'm looking for a 30 by 30 shower enclosure or pre fab shower I can't find a place to buy one
New tub/shower enclosure
[ 1 Answers ]
I currently have a tub/shower combo with a liner (must be 25+ years old). I'm going to rip everything out and install tile, new shower and tub faucet and new rough in valve. I'm just looking for some expert advice or tips on how I should go about doing everything. I figure do my due diligence...
Drywall above shower enclosure
[ 2 Answers ]
I have installed a new shower enclosure. I am installing water resistant drywall above this enclosure. The enclosure is nailed to the studs and protrudes slightly from the studs and not flush. How would I rout out the back side of the drywall (about one eighth inch) so it will fit flat against the...
4 Piece Shower Enclosure
[ 3 Answers ]
"Do they make a drain receptor with female threads on the inside that could be glued to the 2" pipe afer the base is set, and with the drain grate screwing into that?" They do but I'm not too sure you can use it on a manufactured shower base. It's called a "flange type shower drain", (see image)... View more questions Search
|