Ask Experts Questions for FREE Help !
Ask
    rcgrace's Avatar
    rcgrace Posts: 3, Reputation: 1
    New Member
    		  
    #1

    Oct 31, 2011, 08:01 AM
    Ignition failure
    Goodman furnace, starts it's cycle;
    1.inducer motor starts
    2.igniter comes on (glows)
    3.burners fire up
    4. Everything cuts off, cycle starts all over 3-4 times then one blinking light
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
    		  
    #2

    Oct 31, 2011, 08:14 AM
    Is there a peep hole in the door to the lower compartment? Look inside to see if you are getting a small blinking light. If so, tell us the frequency and number of blinks.
    rcgrace's Avatar
    rcgrace Posts: 3, Reputation: 1
    New Member
    		  
    #3

    Nov 1, 2011, 06:45 AM
    One blink (ignition failure) Goodman Furnace
    rcgrace's Avatar
    rcgrace Posts: 3, Reputation: 1
    New Member
    		  
    #4

    Nov 1, 2011, 06:46 AM
    One blink
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
    		  
    #5

    Nov 1, 2011, 07:29 AM
    Remove the door with the peep hole and read the chart. What does it say about one blink?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Ignition failure [ 28 Answers ]

My Goodman furnace shows a one blink code that translates to ignition failure and suggests checking the flame sensor (which I replaced) the gas valve (which I replaced) gas pressure (had new gas meter installed) or restricted gas flow (which I can't imagine) Any help is greatly appreciated.

Ignition failure carrier furnace [ 1 Answers ]

Thk for the reply, I tried connecting a wire from the spark generator post and holding the other end 1/8 inch from the ground. First try a got a short burst of 3 weak sparks. Shut off furnace and re started this time no sparks a all. Checked that there was still voltage going to the SG unit. Guess...

Ignition proving failure [ 12 Answers ]

Carrier model 58RAV. Once a month the heating system's led code shows 14 ignition proving failure,after a couple of hours it resets itself and everything is fine.What gives?

Ignition interlock failure [ 5 Answers ]

What happens if someone who is court ordered to put a breathalyser in his or her fails a test? Is this a violation of probation? What is the probation officer's next move? Does the test record show the level of BAC or is a pass or fail kind of thing? This is all very to me, because technically...

View more questions Search