Ask Experts Questions for FREE Help !
Ask
    eman27's Avatar
    eman27 Posts: 3, Reputation: 1
    New Member
    		  
    #1

    Oct 31, 2011, 06:36 AM
    I have a goodman 100-3 its 15yr old unit
    I replaced the board and worked fine for a day checked everything and I'm not getting 24vt to the gas valve but if I start it normaly and wait for the cycle to run board clicks and I hit it with a wire from the tranformer it works what do I do I need help
    repairman_red's Avatar
    repairman_red Posts: 37, Reputation: 1
    Junior Member
    		  
    #2

    Nov 7, 2011, 06:26 AM
    Check the safeties to see if you're losing power to the gas valve. Does the ignitor glow?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Flash codes for Goodman GMP 100-3 [ 2 Answers ]

Anyone know how to interpret the led codes on this furnace?

What causes my goodman furnace 100-3 to start and restart [ 0 Answers ]

Had ignitor and heat seņor replaced. My furnace is about 16 yrs. Old... It starts up normal Sometime stays on full cycle. Other times starts fires up and then flame goes out and cycle Tries again about 3 time. I then shut down the themastat. Had thermostate checked out also All by licensed...

Goodman GMP-100 [ 1 Answers ]

I have a Goodman GMP-100, purchased in 1996. Never a problem over the years but last year I had to replace the flame sensor. A $5.00 part, NO PROBLEM! Over the last couple months I notice when the thermostat (digital/programmable type) was in the OFF position, the exhaust fan would come on, then...

Goodman gmnt-100 won't light [ 5 Answers ]

My goodman gmnt100 won't light just replaced the ignitor about 3 weeks ago was working fine and then started lighting intermittantly now won't go at all

Goodman 100-3 will not heat [ 6 Answers ]

Problem is with Goodman 100-3. The ignitor will glow and then go out. It does this 3 times then stops completely. No flames at all. Looking through manual can not find where the circuit board is located. I've been researching online and it states to watch for blinking lights from the circuit board...

View more questions Search