Ask Experts Questions for FREE Help !
Ask
    RichWood's Avatar
    RichWood Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Oct 6, 2011, 06:40 PM
    Goodman GMP-100
    I have a Goodman GMP-100, purchased in 1996. Never a problem over the years but last year I had to replace the flame sensor. A $5.00 part, NO PROBLEM! Over the last couple months I notice when the thermostat (digital/programmable type) was in the OFF position, the exhaust fan would come on, then the large blower motor would come on but no flame or A/C condenser. Both fans would run for a couple minutes then shut off. This cycle may occur once or a few times in a row. I replaced the thermostat with a Hunter Electronic/Mechanical Thermostat, Model 40135. I don't recall the fans coming but now it is starting to happen again even with the new thermostat in the off position. Owners manual for thermostat says if system continues to operate when the thermostat is in the off position, replace unit. It has only been installed for about a month. Any suggestions?
    T-Top's Avatar
    T-Top Posts: 1,871, Reputation: 100
    Ultra Member
    		  
    #2

    Oct 6, 2011, 06:45 PM
    To me it sounds like you have a slight 24v short in the system and its putting the control board into test mode.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Flash codes for Goodman GMP 100-3 [ 2 Answers ]

Anyone know how to interpret the led codes on this furnace?

Are 22 coil GMP 100-4 furnace? [ 4 Answers ]

I have an older system GMP100-4 serial # 9508802550. The repair man says I need new R 22 evaporator coils. However he states nobody makes them anymore and instead I need to buy a new system that would cost me $4500. Does anybody know where I might be able to get a hold of these? Thank you in...

Goodman gmp burner [ 0 Answers ]

The burners are burning unevenly and then shutting off. The furnace will start, fans blow just fine, igniter glows and works and then the burners one bye one come on but the third and last one is not blowing a flame as hard or as constant as the other two. Heating contractor wanted to replace...

Goodman gmp 075-3 [ 0 Answers ]

The fan kicks on but the unit does not fire.. just blows cold air... light on board blinks 4 times

Issue with Goodman GMP series gmp 050-3 [ 18 Answers ]

Hello everyone, I have an issue with my furnace. It just recently started happening, when running the ac the unit gets to the set temperature and then the unit clicks as if where going off and clicks again and keeps running. I looked inside and didn't see the status light blink.. Any help here?

View more questions Search