Ask Experts Questions for FREE Help !
Ask
    cherr's Avatar
    cherr Posts: 3, Reputation: 1
    New Member
    		  
    #1

    Oct 26, 2011, 01:58 PM
    Switch for Furnace
    Is the on off switch for the furnace special or will any on off switch work that the furnace plugs into

Check out some similar questions!

Carrier furnace: limit switch fault furnace has ignition but blower will not come on? [ 2 Answers ]

Board says it is a limit switch fault Furace goes into pre ignition, fan comes on and sometimes even the main burner ignites, but the blower will not come on... is this the blower motor or could this be a switch somewhere?

York residential furnace pressure switch problem code stuck switch [ 1 Answers ]

I have a york furnace P2MD12H06401A after 1 hour it shuts down and gives a 2 flash error for a stuck pressure switch. The switch is new can it be wired wrong? The old one had 2 white wires piggy back and 1 blue wire. The new switch has 3 separate terminals

Switch furnace to emergency mode on my Bryant 90 furnace [ 2 Answers ]

I have run out of propane and we are in the middel of a blizzard. How can I switch my furnace to emergency mode? Thanks, Brett

Furnace won't light without a furnace switch reset [ 15 Answers ]

Hello I have a Tempstar/Keeprite furnace model HGF120NE-1, Serial number 8464124770. (the exterior of the furnace has Tempstar logo and interior of furnace has Keeprite logo.) This furnace has an intermittent pilot light system. At times, especially in the morning after allowing a...

Furnace switch [ 3 Answers ]

I have an outside wood furnace. It has three wires in the fan switch. It will shock you when you touch the furnace itself. I can't find any breaks or bare spots in the wires. Any suggestions?

View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.