 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
Check out some similar questions!
I have a Rheem heat pump and have purchased a replacement condenser fan motor. It had an Emerson KA55HXPAM-7255 and was crossed over to an A O Smith ORM 1008. My problem is the wiring, the new motor has one more wire than the old one. I had orange, brown, black on the old one. The new one has...
I’m attempting to replace the condenser fan motor on a Trane XB1000. It originally came with a .25 hp GE motor with mounting stud that are about 3 inches apart. The only suitable replacement that specs out (type, volts, amps, rpm, etc.) is an AO Smith unit, but the mounting studs are about 3.75...
I had to replace condenser fan motor with new and new motor has more wires than old one. Please tell me how should I wire it? The old motor had only 3 terminal. Black was connected to AC circuit board with relay Purple was connected to dual capacitor common Brown was connected to ducal...
I replaced the condenser fan motor on my old Tempstar A/C, but I am a little uncertain about the wiring on the new motor. Attached is a picture of the way I have it wired right now and the wiring diagram that came with the motor. The old motor had 3 wires: Black - wired to T2 contactor ...
I have had to buy a replacement condenser fan motor for my weather king model WAKA-037JAZ. The old motor was a 3 wire motor and the replacement motor is 5 wires. How do I hook it up to the capacitior? What wires to what connector?
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
