Ask Experts Questions for FREE Help !
Ask
    leebs's Avatar
    leebs Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Oct 21, 2011, 11:05 AM
    Evco gas furnace?
    My evco flashes 3 green lights saying it's a combustion air switch is not closed I replaced it but get same 3 green flashes.
    drtom4444's Avatar
    drtom4444 Posts: 3,282, Reputation: 145
    Ultra Member
    		  
    #2

    Oct 22, 2011, 06:03 AM
    The combustion air switch may not be closing because the combustion fan is not running. Is that the case? You could have checked the old switch with a meter to see if it was bad. You will need to get a good meter and learn to use it before you will be able to fix this unit. Guessing and just changing parts will never work and never has. The combustion air fan has a switch to turn it on, so either that switch is not closing or the fan motor is bad. If so you usually need to replace both the motor and the fan because the fan rusts and comes apart from all of the acid exposure. DrTom4444
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Have a rheem criterion 2 gas furnace (1X2000), our gas was out for three days (Tucson [ 0 Answers ]

Have a rheem criterion 2 gas furnace (1X2000), our gas was out for three days (Tucson Az ) Now it’s back on, and both furnaces start and stop about ever 4 to 10 minutes

I have a Frigidaire gas furnace which fires up for a couple of seconds then gas shuts [ 1 Answers ]

My Frigidaire gas furnace has 3 burners that ignite for a couple of seconds then shuts off. The electric ignition and fan works fine, it's just the burners that turns off after a few seconds. If I try turning the furnace on and off a few times it sometimes fires up and stays on. I have tried...

I have a Frigidaire gas furnace which fires up for a couple of seconds then gas shuts [ 0 Answers ]

My Frigidaire gas furnace has 3 burners that ignite for a couple of seconds then shuts off. The electric ignition and fan works fine, it just the burners that turns off. If I try turning the furnace on and off a few times it sometimes fires up and stays on.

Carrier Natural Gas Furnace main gas valve will not open every call for heat [ 1 Answers ]

We have a Carrier Weather Maker 8000 Natural Gas Furnace not functioning properly. We have replaced pressure switch, hot surface ignitor, flame sensor and control board. It will cycle 3 to 4 times and then not come back on. Is it possibly a bad coil on gas valve?:rolleyes:

View more questions Search