Ask Experts Questions for FREE Help !
Ask
    mazzoj's Avatar
    mazzoj Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Aug 18, 2011, 11:29 AM
    My in sink erator won't shut off.
    I have a Pro 17 in sink erator and when we take the plug out the unit won't shut off. We have to unplug it to shut it off. I called a plumber and he said it sounds like it needs a new switch. Who can I contact to fix this problem?
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
    		  
    #2

    Aug 18, 2011, 11:57 AM
    How old is your unit? According to the PDF for this model, it has a 7 year parts and in home service warranty. Yes, batch type disposers can be frustrating as this is a fairly common problem. Is the outlet where your unit is plugged in controlled by a switch? If so, use the switch. If not, and the unit operates well, you could install a wall switch and switch loop the power side. That way, a wall switch will control the unit.
    drtom4444's Avatar
    drtom4444 Posts: 3,282, Reputation: 145
    Ultra Member
    		  
    #3

    Aug 19, 2011, 06:56 AM
    How is it switched on and off? If it's just a wall switch you should be able to replace that yourself by turning off the breaker and replacing the switch. Just make sure to buy at least a 20 amp switch. You probably have too small a switch in it now is why it is bad now. Putting in too small a switch will cause the contacts to weld together which is what has happened. The switch only has two wires and all you need is a screwdriver to replace it. Every homeowner should be able to do this simple repair. DrTom4444
    Stratmando's Avatar
    Stratmando Posts: 11,188, Reputation: 508
    Uber Member
    		  
    #4

    Aug 20, 2011, 06:36 AM
    I believe this is one where the stopper activates the switch.
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
    		  
    #5

    Aug 20, 2011, 09:17 AM
    Pro 17 are batch operated not continuous flow. Put the stuff in and insert the stopper. Switch is in a collar around the mounting ring.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

In sink erator pro17 won't stop spinning after turn on [ 15 Answers ]

The insink erator pro17 which is turn on and off by turning the drain cap suddently won't turn off. No matter how I turn the cap two days ago. I ended up have to turn off the whole house power. Now I can not use the disposal. Do any one know what is going wrong and how to fix it? I can turn it on...

In Sink Erator pro 17 won"t work! [ 34 Answers ]

I have a Pro 17 in sink erator that was in the house we just bought, won't spin. I know this model you put the plug in , spin it ,and it should work, but does nothing. Tested power to the unit and that's fine. Any other things I'm forgetting? Thanks a lot!!

In-sink-erator dishwasher/where do these wire leads go? [ 0 Answers ]

Hi - Just acquired a free, working (but older) In-sink-erator Classic Supreme dishwasher. Problem is, when the owner un-installed it, a few lead wires became unattached from their posts, and I'm not sure which goes where. These are not the main power . Basically, on the rear of the...

In sink erator wiring diagram [ 0 Answers ]

We just replaced our Badger Model 1-81 in sink erator with one purchased at Home Depot. We failed to write down the wiring diagram on the Badger before removing the electrical cord. Now we don't know exactly how it goes. The cord from the Badger has two black lines and one green. Can you help

Uninstallation of an emerson badger 1-83 sink erator [ 1 Answers ]

I have disconnected all of the pipes and hoses but it seems to be stuck and just hanging under the sink. What is the final step?

View more questions Search