 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Can you look in the furnace and let me know which colors hook to what letters on the conrol board. Or even where the wires were hooked on the old thermostat? Either way, red should go to rh, with a jumper between rc and rh. White to w. green to g, and normally blue to y. But it all depends on how they hooked it up in the furnace. |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
I replaced my old White Rogers Heat pump thermostat model number 8848 E7 with a new Digital Hunter Just Right digital thermostat model number 42999B. I followed the directions from the diagram shown in the instructions for a 5-wire heat and cool system. I did the following. G to G, W to W, Y to Y...
I was wondering if any one would know to to reset a heater/cooling system? I just installed a new thermostat and I cannot get my heater/cooler to kick on and start. The last thermostat I had was a Honeywell T8401C and I just put in a Honeywell RTH230B. But the pilot light does not kick in to...
Hi How do I connect the thermostat ? 1) current wring consist of 2 feed and 2 load wires in the wall. The thermostat I want to install has 2 non polarized wires. How do I connect this? Do I connect the feeds to each other and then to the same wire on the back of the thermostat? Then Do...
I live in a Condo which has heating controlled by a boiler system which sends hot water through baseboards along the wall. I am trying to install a new thermostat because I think the previous owners installed an old, junky one right before they moved out and did it incorrectly. We now have...
I'm replacing my old heat pump thermostat(American Standard) with a Hunter Programmable Thermostat(Model 44360). I have seven wires coming in and they are all connected as follows: The white comes in and connects to a terminal labeled X2 and jumper goes up to the terminal labeled W. Green...
View more questions Search
|
