Ask Experts Questions for FREE Help !
Ask
    Oma Harvey's Avatar
    Oma Harvey Posts: 1, Reputation: 1
    New Member
     
    #1

    Jul 31, 2011, 03:58 PM
    Faucet problem
    Turned on cold water and was a loud, popping noise, then no more cold water. Hot still works. This is a Delta single kitchen faucet. Before this happened, in using spray hose, both sprayer and faucet ran at same time. This happened once before right after moving in 11 years ago. Builders plumbers repaired within 15 monutes. Did'nt see what they had done. Thank you.
    afaroo's Avatar
    afaroo Posts: 4,006, Reputation: 251
    Ultra Member
     
    #2

    Jul 31, 2011, 06:44 PM

    You may have dirt in the cold port of the faucet, here is what you need to do, close the angle valves under the sink, remove the handle and the cartridge, Place a towel on top of the faucet and open the angle valve slowly one at a time for a few seconds to flush out the dirt, once it is flushed assemble the cartridge and the handle, check if works, good luck.

    John
    speedball1's Avatar
    speedball1 Posts: 29,301, Reputation: 1939
    Eternal Plumber
     
    #3

    Aug 1, 2011, 07:23 AM

    using spray hose, both sprayer and faucet ran at same time.
    This tells me that the problem's in the diverter. This is located in the front after removing the spout assembly. To tell you more I need the make and model number of the faucet, Also its age. Cheers, Tom

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Moen Faucet Removal Problem [ 1 Answers ]

I am having trouble getting my single faucet handle off so I can get to the cartridge for removal.We bought a hex allen wrench but found out the thing underneath the handle is not shaped that way it is actually round any suggestions on how to get this off would be greatly appreciated.

Kitchen faucet problem [ 1 Answers ]

Cold water comes out of the kitchen faucet but the hot water side does not. Started getting weak then eventually stopped working.

Glacier Bay Faucet Problem [ 0 Answers ]

I have a Glacier Bay kitchen sink faucet, the pull-out on the faucet that clicks in, doesn't stay. The sprayer falls out when the water is turned on, sprayer just hangs. Can this be fixed? Thanks, Aymee

Faucet problem [ 2 Answers ]

My faucet is a two-handle faucet... It was already here when I moved in which was over 3years ago. Unfortunately I do not know the brand nameof the faucet or model number. :-(

Faucet seating/leaking problem [ 1 Answers ]

We Have A Glacier Bay Bathroom Faucet That's Been Dripping. A Series 300 That Uses The Small 7/16 Rubber Boot And Spring That Fits In Approp. Hole In Water Supply Then Over The Top Fits A Turnable Water Control. Well, I Have Replaced This Type Before W/o A Problem But This One Leaks After New Ones...


View more questions Search