Ask Experts Questions for FREE Help !
Ask
    kitkatSA's Avatar
    kitkatSA Posts: 3, Reputation: 1
    New Member
    		  
    #1

    Jul 27, 2011, 07:02 AM
    Design Process for a square pipe clamp
    I have a homework assignment to outline a design process and create 3 freehand concept drawings for a wall mounted clamp that can hold a 40mm wide square pipe.

    I am completely unsure about what to do and what kind of information I need to gather.
    kitkatSA's Avatar
    kitkatSA Posts: 3, Reputation: 1
    New Member
    		  
    #2

    Jul 27, 2011, 07:04 AM

    I apologise! I was not registerd when I asked the question so I was unable to see the sticky about homework.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

A yellow square is inside of a green square. What is the theoretical probability that [ 1 Answers ]

Vent pipe design. [ 4 Answers ]

How many plumbing vent pipes can tie into the same two inch vent pipe going through roof ?

Riser clamp [ 2 Answers ]

After reading a bunch of questions and answers on this forum, I think that I need to use a riser clamp. My problem is that I have been unable to find a riser clamp at the local home improvement stores. Do "riser clamps" have a different name? Or are they relatively uncommon (i.e. not stocked...

Design for a pipe pillar [ 1 Answers ]

I have to design a pipe pillar which has to bear the load on top for 1000 kg at a height of 7 meters. The wind speed is expected to be 100-150 km/hour. The load on top has a width of three meters and a height of 3 meters. Provide me with the minimum diameter and thickness of the pipe required to...

Replacing tub spout but pipe not square with wall [ 12 Answers ]

I took off the old tub spout and am replacing it with a new one... just a simple universal one that has a diverter. Thought that this would be an easy task, but the pipe stub isn't square with the wall, so when the spout is installed, there is about a 1/4" gap on the top between the wall and the...

View more questions Search