Ask Experts Questions for FREE Help !
Ask
    elm267's Avatar
    elm267 Posts: 2, Reputation: 1
    New Member
     
    #1

    Jul 25, 2011, 10:15 AM
    Deere L110 Stalls
    My Deere L110's battery died. I replaced it and it started up fine. I began mowing but when I was going downhil and turned to the left the engine died. I checked the fuse below the started and it was blown. I replaced it and started up again, no problem. Mowed around until I went downhil and turned to the left... DIED AGAIN. This same situation occurred 3 years ago when I replaced the battery. Then I took it to service and they fixed it saying they had to replace some wires. Should I relace the battery cable with the battery? Any other Ideas?
    DG's Avatar
    DG Posts: 1,375, Reputation: 109
    Ultra Member
     
    #2

    Jul 25, 2011, 02:24 PM

    Don't go down hiil or turn left.
    Just kidding :)
    Look under the engine rt.side sitting on it .
    There are wires there check them make sure they are not rubbing
    Check wires that run behind engine side to side .
    Might even check fuse holder make sure fuse is going in tight.
    Look for bare spots in all wires by engine
    Luck
    elm267's Avatar
    elm267 Posts: 2, Reputation: 1
    New Member
     
    #3

    Jul 27, 2011, 08:14 AM
    Hey DG-
    Thanks for the response.
    I looked at everything and pulled and pushed wires and connectors to see what might be loose. I checked all the wires and looked to see if any were bare or rubbing. I stared it up and it ran fine. Started to mow but went really sllloooow... Everythnig went fine. As the morning progressed I got a little more bolder and went faster, but still not as fast as I usually go. Didn't shut off once. Still a little leary. I wish I could have found something, but I figure in my pulling and pushing and moving everything around I fixed something I didn't even know was wrong. Maybe I won this one!
    Thanks Again

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Help my John Deere L110 stalls! [ 2 Answers ]

Anyone with any suggestions? My 2003 John Deere L110 w/ Kohler 17.5 HP engine stalls after about 30 sec-1.5 minutes. Of cutting operation. It will sometimes idle for 2-3 minutes. Before stalling. I have tried flushing the fuel line, replaced the fuel filter and spark plug, added fuel system and...

John deere L110 54 [ 2 Answers ]

I am looking for a L110 54" deck belt drive diagram. Can You help ?

John Deere L110 [ 1 Answers ]

I have a John Deere L110 in the Manual it give me the Gap Size for the Spark plug but Does not give me info on the Plug itself, What Manufactor is the plug and the Plug Number? I can not read what is currently on the Org plug. Thanks for your time, Chris

Deere L110 [ 1 Answers ]

How do you remove the carburetor bowl ? What is the purpose of the electrical connection attached to the carburetor ? I have water in the fuel system and want to clean the carburetor bowl. Can't see how it is attached.

John Deere L110 [ 3 Answers ]

I have a 2003 John Deere L110. At the beginning of this mowing season, when I cranked it, the engine tried to crank with it in the run position and stopped cranking in the crank position! Then it just stopped cranking altogether. I replaced the ignition switch and that did not help. I replaced...


View more questions Search