Ask Experts Questions for FREE Help !
Ask
    KC2003's Avatar
    KC2003 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Nov 6, 2010, 02:43 PM
    Help my John Deere L110 stalls!
    Anyone with any suggestions? My 2003 John Deere L110 w/ Kohler 17.5 HP engine stalls after about 30 sec-1.5 minutes. Of cutting operation. It will sometimes idle for 2-3 minutes. Before stalling. I have tried flushing the fuel line, replaced the fuel filter and spark plug, added fuel system and carb cleaner, and cleaned the air filter. I am technical enough to go further, but don't know what diagnostic path to follow. The fuel pump apparently is functioning OK also. Your thoughts? Much appreciated ! Keith
    crigby's Avatar
    crigby Posts: 4,343, Reputation: 107
    Outdoor Power Equipment Expert
    		  
    #2

    Nov 7, 2010, 10:52 AM

    Hi,
    The fuel pump could be working, yet not pump sufficient fuel. It will usually have a broken diaphragm and leak into the crankcase. Tell that by smelling the oil on the dipstick to detect the odor of gas.
    Another common problem with that model is the fuel line becoming pinched between the tank and frame at the rear. There is a slot in the tank that the line fits in and it can sometimes shift out of that slot(usually to the right) and pinch off the fuel flow. It is easily visible and correctable by hand from above and below.
    Peace,
    Clarke
    B1LLY's Avatar
    B1LLY Posts: 1, Reputation: 1
    New Member
    		  
    #3

    Aug 22, 2011, 12:12 PM
    Clean the breather hole in your gas cap if your L110 is running for awhile, then stalling.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

John deere L110 54 [ 2 Answers ]

I am looking for a L110 54" deck belt drive diagram. Can You help ?

John Deere L110 [ 1 Answers ]

I have a John Deere L110 in the Manual it give me the Gap Size for the Spark plug but Does not give me info on the Plug itself, What Manufactor is the plug and the Plug Number? I can not read what is currently on the Org plug. Thanks for your time, Chris

John Deere L110 [ 3 Answers ]

I have a 2003 John Deere L110. At the beginning of this mowing season, when I cranked it, the engine tried to crank with it in the run position and stopped cranking in the crank position! Then it just stopped cranking altogether. I replaced the ignition switch and that did not help. I replaced...

John Deere L110 [ 3 Answers ]

John deere model L110 Mower was working fine. I got off it to add more gas, when I got back on it would not start. I turn the key and nothing, no clicking, nothing. I disconnected the pressure switch from the seat and still nothing. Mower blades are not engaged. What am I missing, it still...

View more questions Search