Ask Experts Questions for FREE Help !
Ask
    homeowner156's Avatar
    homeowner156 Posts: 1, Reputation: 1
    New Member
     
    #1

    Jul 5, 2011, 10:29 AM
    York air and heat troubleshooting?
    I have a york split system heat pump. Five lights blinking on thermostat, 7 blinks on default code at compressor. Reset boards. 2 to 5 days later five blinks on thermostat, 3 blinks at compressor. 2 to 5 days later, five blinks at thermostat, 5 blinks at compressor. Within 2 to 5 days the outdoor unit will shut off, bad board? I can't see the unit having all the problems every time the boards are reset. Tech said refrigerant is fine unit runs fine after reset for 2 to 5 days.
    Upset_Homeowner's Avatar
    Upset_Homeowner Posts: 1, Reputation: 1
    New Member
     
    #2

    Jul 5, 2011, 05:15 PM
    I bought a York A/C last year. 1st time I used it it blew the preasure switch. Used it for only 3 weeks last year. This year, I turned it on for the first time and it will not work. Motor blew out.

    York is a lemon. I am told it will take 5 days to get the part. I emailed their customer service and they have not responded. York is a lemon DO NOT BUY.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Heating-air-conditioning/troubleshooting-york-diamond-80? [ 0 Answers ]

My York Diamond 80 furnace is blowing cold air. There is an indicator blinking twice. Is there a way to reset?

York furnace troubleshooting [ 0 Answers ]

Hi, I have a furnace that goes for 3 hours and when it try to stop the thermostat does not stop blower (fan ) it run continue. Plase help me. Best regards, Vladimir [email protected]

York heater troubleshooting [ 10 Answers ]

I have a york diamond 90 model P3UR When I raise the temp, the blower goes on, then I see the pilot get hot ( glow ), then blower goes on for about 30 seconds and shuts off. This goes for 3 cycles then stops. Tried cleaning the flame sensor... still does the same thing Can anyone help? Thanks

York heater troubleshooting [ 2 Answers ]

I have a york diamond 90 model P3UR When I raise the temp, the blower goes on, then I see the pilot get hot ( glow ), then blower goes on for about 30 seconds and shuts off. This goes for 3 cycles then stops. Can anyone help? Thanks

York forced air heater with electronic ignition troubleshooting [ 5 Answers ]

I have a York forced air gas fired heating system with I guess a direct ignition instead of a standing pilot light. When the system comes on, the blower comes on and then a couple of seconds later the gas valve clicks and some gas goes through but no ignition. Then the gas valve clicks again but...


View more questions Search