Ask Experts Questions for FREE Help !
Ask
    jsemelgar's Avatar
    jsemelgar Posts: 5, Reputation: 1
    New Member
     
    #1

    Jun 15, 2011, 05:19 PM
    Is my r22 a/c split system over-charged or need cleaning?
    I'm no A/C tech, just a DIYer with Fieldpiece diagnostic tools and a desire to learn. I have an Amana 12 SEER R-22, Non-TXV residential split A/C about 10 years old. My home is 2200 Sq Ft. located in Houston, TX.

    I was wondering if the high side reading is too high?
    If yes, would the evaporator need cleaning, since it's never been cleaned?
    You opinion of the system will be much appreciated?

    My readings after 20 minutes of run time are:
    Low side gauge PSIG: 80
    Low side line temp: 65.5 F
    Low side gauge temp: 48 F

    High side gauge PSIG: 330
    High side line temp at condenser: 98.4 F
    High side line temp at evaporator: 101.5 F
    High side gauge temp: 138 F

    Outdoor ambient DB temp at condenser: 100.1
    Indoor WB temp at return grill: 68 F

    Nearest grill to evaporator: exit DB temp: 77F
    Nearest grill to evaporator: exit WB temp: 56F
    I think TEET should be: 54.5
    I think non-TXV target superheat should be:12 ((68x3)-80-100) /2
    Actual superheat is: 17
    Filter is clean.

    Your evaluation will SURELY be appreciated. Thank you in advance, Jim.

Check out some similar questions!

R134a in an R22 system [ 4 Answers ]

What would the effects be if an r-22 system were to be evacuated and filled with R134a? What is the reason that this equipment can not handle this gas?

Do I have to replace the whole r22 system if I upsize from a 2 to a 2.5 ton r22 unit [ 6 Answers ]

My r22 heat pump unit is undersized for my house. It is a 2 ton and the builder should have installed a 2.5 ton. Do I have to replace the whole system, inside and out, if I upsize to a 2.5 ton or can I change out just the part that is the wrong size to cool the house? I can't really afford the cost...

Cleaning a system with r22 & 410a mixed [ 1 Answers ]

I reused my line set because it was in a wall. The outside condenser and a coil were replaced but the old line sets were not cleaned. There may be a mix of r22 and 410a in my new system. Can the system be flushed completely. I was going to replace the A coil and try flushing the compressor and...

How much more expenseve is a 410 system vs an r22 system [ 2 Answers ]

How much more expensive is a 410-a system vs an r-22 system


View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.