 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Foot valves - brass or plastic?
I need to replace the foot valve in my well. Our water seems to corrode metals very slowly. It's got a lot of dissolved mineral salts, very hard water. I'm thinking of using a plastic foot valve to replace the brass one that's there now. I have a deep well, 2-line system with the pump in the basement. Does anyone have experience with this type of situation?
|
||||
Check out some similar questions!
It is midway down my right foot and only foot massage seems to apease it, but itsgetting worse and hurts earlier and earlier each evening. The central point is midway and for the ultimate in relief is to squeeze my feet down the sides, but that also sends me into agony once squeezed, but the long...
Can I use brass compression fittings with 15mm plastic pipe? Thanks!
Which compression fittings work better? Those with plastic pipe or those with brass pipe?
Hi Folks, New here. Problem: I need to glue a quarter sized brass washer to a smooth, flat, hard plastic surface (no, I don't know what kind of plastic). Requirement: Stand up permanently to light to moderate stress on a G scale model railroad. The plastic pivot pin on the motorized...
In a condominium constructed about 12-15 years ago in Henderson, NV, I discovered 6 out of 8 under-sink water shut-off valves to have badly corroded valve stems, if that term can be legitimately applied to plastic. The "corrosion" was so bad that one valve had failed causing a flood. Since 75% of...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
