Ask Experts Questions for FREE Help !
Ask
    taylorgang37's Avatar
    taylorgang37 Posts: 1, Reputation: 1
    New Member
     
    #1

    May 24, 2011, 12:32 PM
    Bad sensor...
    I have a 97 mazda 626 and I have a sensor that's out... anyway the car don't skip but it act like it doesn't want to go up a hill and the rpm gets high as well... this happened to me over a decade ago and it was a sensor that went bad, can anybody help me?
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
     
    #2

    May 24, 2011, 04:45 PM

    Check for codes.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

MAP sensor;Mass Airflow sensor;Volume Air sensor-All Same? [ 8 Answers ]

97 Nissan Pickup - 160,000 miles - KA24E engine -Check engine Soon Light Code reader says volume air sensor. Is this the same as a mass airflow sensor or the MAP sensor? Where is this sensor located, in the throttle body injection? Just threw a new O2 (Bosch)sensor on it, I lost that bet.. it...

Could a bad maf sensor cause a 95 oldmobile 88 to not start? [ 0 Answers ]

95 olds 88 won't start without starting fluid. Could it be the maf sensor?

How can I know if the cam position sensor is bad before I replace it. [ 1 Answers ]

A 1997 Plymouth Grand Voyager, the service engine light comes on occasionally when the car dies when idling by a light. Better gas was purchased and the light went on while driving at like 30mph rpms fell but didn't die service engine light came on. Code suggests the cam position sensor is bad....

Bad Coolant Sensor warning light [ 5 Answers ]

I have a 1994 Jeep Grand Cherokee Limited. It has a new V.I.C in it that constantly says the coolant sensor is bad. I have replaced the coolant sensor. Now what do I do? Please help -- Ace

Bad Flame Sensor? [ 1 Answers ]

Thermostat calls for heat Blower comes on for 30 seconds Ignitor glows Gas kicks on & gas ignites in first burner Travels down the to the other three burners including the last one where the flame sensor resides Furnace stays lit for a few seconds and then goes out with a lockout code The...


View more questions Search