Check out some similar questions!
Replacing a Lennox Thermostat with a Lux Thermostat
[ 3 Answers ]
I have an older analog Lennox thermostat and am replacing with a Lux ATX500 thermostat. The Lennox thermostat connections do not match those on the Lux. The Lennox is a 6 wire connection with terminals: F, V, R, X, Y, M The Lux has terminals: G, Y, W, RH, RC The Lux instructions are very...
Lux ultra 1000 thermostat
[ 3 Answers ]
I have a Lux Ultra 1000 Thermostat, I think that the room temperature it shows is off. It will read 68, but a second thermometer (placed a few inches below it) reads 64. Is there anyway to calibrate the unit, or should I just get a new one?
Wiring lux tx1500e thermostat?
[ 0 Answers ]
I just purchased LUX TX1500E thermostat to replace old CT87A Honeywell. The Honeywell was wired as follows: green – G, White – RC, Yellow – Y & W and Red – was not label, but I'm assuming this is the 24V power. I did wire the LUX TX1500E as it shown on the schematic for Heating and...
Lux thermostat TX1500 heat does not come on
[ 0 Answers ]
Just insatlled a Lux TX1500 thermostat the fan works the air conditioning works but heat does not. Followed wiring diagram.Not sure what to do or try?
Wiring a lux 1500e thermostat for heat pump
[ 0 Answers ]
I am trying to put in a Lux TX1500E thermostat, replacing a trane weathertron. I have a humidistat attached that will control the thermostat. The trane wiring is: g-green, o-orange, x2 looped to u, y-black, t-brown (humidistatwire), r-red (humidistat wire), w-white, u-looped to x2, f--empty,... View more questions Search
Add your answer here.
|