Looking for the oil reset

todd2 Posts: 2, Reputation: 1

New Member

Apr 19, 2011, 08:21 PM

Looking for the oil reset

Where is the oil reset for a 2005 f-250 6.0 litre can someone tell me please

CaptainRich Posts: 4,492, Reputation: 537

Cars & Trucks Expert

Apr 20, 2011, 05:57 PM

Google that one and see which site has yours.

Add your answer here.

Check out some similar questions!

Reset Button on Oil Furnace [ 1 Answers ]

I have had two ignition transformers replaced on my oil furnace and istillhaveto push the reset button in the morning to start it again. Why?

Lennox elite series oil furnace.. . runs once then pops reset [ 1 Answers ]

Clean fuel,full tank,new filter, bled air,new nozzle.Furnace burns fine for one cycle(3 minutes.)then pops reset when starting next time.. I have to wait 2 hours before I can run it again... if I try within 10-15 minutes reset stays down but I don't see spark or flame in view window? Ignitor...

Oil primary control reset will not reset. [ 2 Answers ]

Oil primary control green light flashing. Will not reset due to loss of prime. Just Finished cleaning. Changed filter and obviously Has to be bled. AFG model Becket burner 2 years old. How do I get the reset to reset so I can bleed the system? All working till now. Bruce

Oil burning furnace-reset light blinking-won't come on. Line stopped up? If so, how c [ 1 Answers ]

I have an oil-burning furnace (AirEase Advantage is the brand) It won't run. Last p.m. it would kick on & you could hear it trying to light but it never did & went back off. I would push the reset button & try again. Then it wouldn't allow me to re-set it anymore(light keeps blinking, even after...

Oil burnerr reset trips occasionally [ 1 Answers ]

My oil burner control safety trips and cuts off the furnace about once a month. Resetting it by pushing the red button easily restarts the burner. There is a wisp of smoke expelled around the flame viewing cover plate so I assume that some oil was left in the combustion chamber from the previous...