Ask Experts Questions for FREE Help !
Ask
    jccop828's Avatar
    jccop828 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Apr 18, 2011, 09:50 AM
    Honda ECM testing
    Vehicle was running and all at once stopped
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
    		  
    #2

    Apr 18, 2011, 02:07 PM

    Perform the tests below:

    https://www.askmehelpdesk.com/cars-t...tml#post229012


    It's very possible the Ignition Control Module (ICM) and coil need replacing, if the CEL comes on for 2 seconds and then goes out, when the ignition switch is turned to ON (Position II):

    https://www.askmehelpdesk.com/cars-t...tml#post265896
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Resetting the ECM and Testing the Main Relay [ 1 Answers ]

I keep seeing people telling you to disconnect the negative terminal to clear the ECU. This is a poor choice and will result in having to reset the radio presets and the clock. Simply go to the main fuse box located on the passenger side inner fender. Remove the 15amp fuse in position 37, the...

92 Honda civic possible ecm [ 5 Answers ]

Have a 92 Honda civic. Would not start, fuel pump check,relay check and fuses OK. Does the ecm control fuel pump relay? Started checking voltage on MAP sensor when I plugged it back in, it started . If MAP sensor is going out will it fail to activate the fuel relay? Can the ECM be failing...

ECM location on 92 honda civic? [ 1 Answers ]

My 92 honda civic will crank but won't start

Ecm location on a honda civic [ 1 Answers ]

Where is the ecm in a1998 honda civic

Belgium, after testing ecm [ 1 Answers ]

OK, thanks greased- I have performed this things you mention The test map-ecm is 5 volt. I took out the fuel tank, looking for the closingvalve in the pump , its inbedded in the housing. I pressurized it with the compressor set at 30 psi ,and its closing correctly,no problem. Working on these...

View more questions Search