Ask Experts Questions for FREE Help !
Ask
    glendonrhoden's Avatar
    glendonrhoden Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Apr 10, 2011, 12:17 PM
    I have a 1995 Ford Explorer
    When you put it in drive it doesn't move , it only drives in low 4wr. So what is the cause of this problem? What can I do about ?
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
    		  
    #2

    Apr 10, 2011, 12:34 PM

    Clutch packs are likely shot, if you have not been dropping and cleaning the pan, changing the filter, and replacing the ATF every 30,000 miles. Odds are that you are looking at a rebuild or replacement.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

1995 ford explorer xlt 4.0 transmission problems [ 17 Answers ]

I changed the transmission fluid on my 1995 ford explorer xlt. I than drove it around the block and the overdrive off light started to blink and the transmission was struggling to change gears. I couldn't get the overdrive off light to shut off. What is my problem?

I have a 1995 Ford Explorer XLT 4x2 auto [ 3 Answers ]

I took my kid to the store and got there fine. On the way back I had problems with the truck in forwards gears and when I got home the reverse gave in. Original trans and at 158k mi this is the first problem I had. What's going on?

1995 ford explorer transmission problems [ 1 Answers ]

OD light flashes, goes in drive up to 25 mph then then kicks out and studders. It also only makes studdering noise in reverse. Fluid is good and red and not burnt smelling at all, please help if you can.

View more questions Search