 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Goodman AC Problem
Hey all, AC problem started today. I turn the AC on and air begins blowing inside house but it was not cold. So I went outside to the unit and the could not hear the compressor running but the unit fan was running, but then the fan suddenly stopped for like 1 second then started immediately back up. This kept happening about once a minute, just stop for a second then start immediately back up. Any ideas?
|
||||
Check out some similar questions!
I need part number B13707-23A made by United Technologies HSA electronics. Is this part available?
Goodman NG heater. Cycles to the ignitor, hear a click on the circuit board but no flame. Trouble light stays on steady showing no issues. Have replace circuit board, manually checked pressure switch, checked flo switches.
I have a Goodman Dependable Nintytwo furnace. The draft inducer motor comes on but the furncae does not light. The motor will run for long periods. It will kick off then kick back on and the furnace will light. The furnace is not consistent, sometime it lights and sometimes it does not. It has...
I have two goodman furnaces. They both heat up, but, they both have erratic or uneven sounding flames. They run for a while and then click the flame sensor snap switches off. What would cause this, especially same problem on 2 different units?
I have a Goodman GMP 100-4 running on propane The last week or so, has seen some intermittent operation. The draft inducement motor comes on but at times no ignition occurs. Vacuum manually applied to the vacuum switch results in ignition taking place. Inducement motor area has been cleaned out....
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
