Ask Experts Questions for FREE Help !
Ask
    hrogers's Avatar
    hrogers Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Apr 4, 2011, 11:10 AM
    My washer
    I have a Kenmore washer model # 41743042200. The wash cycle works OK, but when it goes into the final fast spin, it makes a loud knocking noise. What can I do to repair it and what parts are needed for the repair?
    JimGu's Avatar
    JimGu Posts: 92, Reputation: 4
    Junior Member
    		  
    #2

    Apr 4, 2011, 12:42 PM
    Unfortunately I have some bad news for you. With this washer, that problem is usually the rear drum bearing. It is not replaceable as a single part. You replace the inner basket and the rear half of the outer drum. Open the door and reach inside and try to lift the basket from near the front and you will probably find your problem is the rear drum bearing by up and down play in the basket. Repairs out of warranty for this are just not economically viable. You'd be looking at in excess of $450, probably quite a bit more. Some of the models have the entire outer drum and basket as an assembly, but still not economical and not something a novice would want to try.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Kenmore washer dryer combo, washer agitates for about 10 seconds then it stops. [ 1 Answers ]

The washer will fill and it will agitate for about 10 seconds, then it will stop.When it stops there is no motor sound.Then after about one minute it will start by itself and repeat the same thing over and over no matter what I set the knob to it does the same thing. Could it be the timer?

Kenmore stack washer/dryer - washer makes noise during wash [ 2 Answers ]

My son has a Kenmore stack washer/dryer that makes a noise that sounds something like a gear when washing only. Could this be a transmission problem? Jay

I have a maytag bravos washer. I have a problem that when my washer is in rinse mode [ 0 Answers ]

I have awasher it's a maytag bravos, it fills with water when on rinse mode but does not kick on to spin mode it shuts off with an error code that reads ol on the screen and makes me start over again.what can I do

Drain pipe for washer backing up once washer starts to empty what could be causing [ 4 Answers ]

What couild be causing the drain pipe fro washer to back up and spill all over floor behind washer

Kenmore washer dryer combo 110-92966-102,washer agitates for a little then it stops. [ 0 Answers ]

Kenmore washer dryer combo 110-92966-102, The washer will fill and it will agitate for a little bit for about a minute, then it will stop before finishing.When it stops there is no motor sound.No matter what I set the knob to it will not start up again,but if I wait several minutes it will...

View more questions Search