 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
Check out some similar questions!
The pilot of the wall is on, but when I turn on the thermostate , the burner do not star.I all readi change the thermopilot
Hello; I have a LP Empire Wall Furnace model # FAW-55 SPP in my garage (hooked to a 20lb tank-full). I turn on the gas & ignite the pilot light. After a few seconds the pilot will stay on by itself as it is suppose to. I then turn the control on the furnace to "On" & the thermostat is set to at...
I have an empire floor heater and the temp will not go to "off" or down to the pilot. I have changed the thermastat and the problem still persists. Basically after the pilot is lit, the heater will crank to high or close to it and it won't turn down. Has anyone had this problem before and how...
I have a 1985 vintage Empire gravity direct vent wall furnace in out cottage mode # DV-235-3SG. Once the unit runs for a while and the room comes up to temp. the burner shuts off, but the blower keeps trying to cycle on and off - it makes an electrical sparking sound which causes interfence with...
:o, Please help! I have accessed the inside of my Empire wall furnace & understand the instructions on the knob relating to startingg the pilot light. Have lit pilots of water heaters many times. My question simply is: Where is the place to place the match to get ignition? It refers...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
