Ask Experts Questions for FREE Help !
Ask
    FrankenFraud's Avatar
    FrankenFraud Posts: 19, Reputation: 10
    New Member
    		  
    #1

    Mar 16, 2011, 11:25 PM
    Empire wall furnace burner ignition problem.
    Hello; I have a LP Empire Wall Furnace model # FAW-55 SPP in my garage (hooked to a 20lb tank-full). I turn on the gas & ignite the pilot light. After a few seconds the pilot will stay on by itself as it is suppose to. I then turn the control on the furnace to "On" & the thermostat is set to at least 75 degrees. But the burners never light. Last year the furnace worked fine for the few times I used it. Now, zippo! I took the front cover off, used compressed air (nothing outrageous) on the burners but, nothing helped. Any clues what might be the problem? Thanks

Check out some similar questions!

Have to bang on Empire 5088 floor furnace to get main burner to come on each time. [ 0 Answers ]

Problem with empire wall furnace [ 1 Answers ]

I have a 1985 vintage Empire gravity direct vent wall furnace in out cottage mode # DV-235-3SG. Once the unit runs for a while and the room comes up to temp. the burner shuts off, but the blower keeps trying to cycle on and off - it makes an electrical sparking sound which causes interfence with...

Lighting Empire wall furnace pilot light [ 1 Answers ]

:o, Please help! I have accessed the inside of my Empire wall furnace & understand the instructions on the knob relating to startingg the pilot light. Have lit pilots of water heaters many times. My question simply is: Where is the place to place the match to get ignition? It refers...

Furnace blower going but burner not igniting [ 1 Answers ]

My furnace was going on and off very frequently for the past two days. Now the blower is going but the burner is not going on. Any ideas?

York furnace - No ignition,no heat [ 4 Answers ]

I have a York Gas Furnace (model# P2MPD14W08001B, 12yrs old) giving out no heat. I did basic troubleshooting and realised system was not igniting; replaced ignitor (changed original 4-5 years ago) - fired up initially and then went out after running for about 30 minutes. I cleaned the flame sensor...

View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.