 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Heat Pump working instead of A/C
Had mother board replaced in condenser during summer, in the winter noticed condenser was frosting over, replaced mother board again, had a warm day, tried to use A/C, heat came out of registers, tech. claims there was a problem with control wires broken wire or wires, is this possible %'s or was the unit miss wired while being worked on. I do not understand how it is possible for broken wires to cause you to get heat when you have the A/C on, but I do believe it very possible to get this from bundling wires wrong. Am I right or wrong or is there a gray area?
|
||||
Check out some similar questions!
The thermostat is operating/clicks on when desired temperature is more that the actual, but no action at the compressor or fan. We even switch thermostats from other unit in house and both operate the other unit correctly.
I have a goodman heat pump it will work in cooling mode but not heating. When I put in heating mode the air handler will kick on and the back up heating stripes work but the heat pump does nothing. I have replaced the transfomer on the air handler when it burned up and also replace the contactor...
I have a coleman heatpump and the other day the fan out side quit running. Someone came out and replaced the relay switch. Worked fine for a few hours, Then it shut off again but the inside fan kept running until I cut it all off. Any suggestions?
Heat strip not working on my goodman heat pump
Hello. I have a relatively new house (2.5 years) that has an American Standard Heat Pump (2a6b3018-060a1000a). It also has some form of American Standard aux heater (bayhtr?? ) in the air handler. This is controlled by a Panasonic TH8000 thermostat. We have had a long period of cold weather here...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
