Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Help with a Peerless Two Handle Kitchen Faucet w/Sprayer
[ 4 Answers ]
Culprit: Peerless Two Handle Kitchen Faucet w/Sprayer Two part question: 1) Need instructions and photo illustrations (if possible) on fixing a dripping faucet; and 2) same for separate sprayer worked fine just after install but now it does not spray. A slight stream of water is coming from the...
Shower handle replacement
[ 3 Answers ]
I'm replacing my whole shower. There is a shower head and a handle. I've removed the handle and note a round copper stem with a flat bottom, sticking out from the center of the hot/cold connector. It is about 1/4" diameter. Is this a standard set up? Will any replacement valve fit on it or are...
Shower insert leak at metal handle
[ 5 Answers ]
Request any advice on how to seal a metal handle that is an integral part of a shower insert. I've had a plumber look at the situation. His comment was that shower inserts with metal handles were no longer sold because they developed leaks at the juncture of the metal handle and the holes on...
Shower Handle
[ 1 Answers ]
The single handle shower control knob needs to be turned slightly on to prevent dripping at the faucet when turned off. I also can't seem to get the water hot enough for my shower. Am I just catching the water heater at a "down" cycle or is something deteriorating in the handle mechanism?
Kitchen faucet handle
[ 1 Answers ]
I am trying to get off my kitchen faucet handle (single faucet) but the hex nut that unlocks it will not turn. Any suggestions how to unloosen the hex nut? I tried vinegar and oil with no success. It is a Kohler single faucet kitchen sink. Thanks, gatnus View more questions Search
|