 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Question diagnostics Payne Furnace?
I have a Payne Furnace 32 years old. Replaced Thermal Coupler 2 years ago. Other night the furnace stopped pilot light on but fan/blower would not start. Next day I turned on heat and it started up and continued running until I turned it off. What could be the problem?
|
||||
Check out some similar questions!
I have a Goodman Furnace Model GMPN060-3. I get three blinks biagnostic code. I changed venter (motor assembly) and pressure switch. Still the same three blinks. Moisture drain path is clean and free of debries. After the new parts, furnace started once, but would not start again -- same three...
The orange status light blinks fast indicating reversed polarity. But when I change the polarity it does not stop blinking the code. I checked the breaker panel for correct wiring the receptacle is good. Transformer and inducer motor are connected correctly to the board. Could I have a bad primary...
Concord hot air furnace doesnot fire up. The diagnostic is telling me rollout open. What is this and can I fix it myself?
I have an Intertherm Furnace in a mobile home that I own and rent out. The furnace has a self diagnostic capability and shuts down periondically. The indicator lamp(red light) flashes in a series of four (4) flashes after it has shut down. I can reset it very easily by turning off and back on the...
Manufacturer: Payne 395A AW 48090 Age: 14 years Efficiency: unknown Type of system: forced air Type of fuel: NG. Hello, I have a question about the circuit board on a Payne residential HVAC unit. When I turned on the heat this year, there was the usual sounds of the unit firing up, but...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
