Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Low hot water pressure to tub (only) after replacing hot water tank
[ 1 Answers ]
I just replaced my hot water tank and installed a new one. Now, the hot water pressure in the shower/bathtub (only) is weak - all other faucets seem normal, and the cold water in the shower is fine. Water pressure was fine before I replaced the tank, the problems with the old one were that the...
New water tank, not staying hot or providing enough hot water
[ 0 Answers ]
My landlady has just installed a new water tank, as the old one started to leak, had no thermostat to control the temp, so the water was always very, very hot and not earthed, plus I was worried about escalated costs to heat? The water tank is heated by electric only, was econ 7 now just...
Replaced a hot water tank,water is not going to the pressure tank-the pump stays on
[ 2 Answers ]
Replaced a hot water tank, turned the pump on and the water is bypassing the pressure tank. The pressure tank will not fill up and the pump remains on and will not shut off. We do get water though but needs to shut off the pump so it will not burn out. Any thoughts? Thank you Any ideas will...
Hot Water Tank: Early AM behavior - no hot water.
[ 1 Answers ]
I have a gas hot water tank (apx. 40 gallons). The tank works great, though I'm perplexed with one behavior. No hot water early in the mornings. If the hot water was not used recently (say a day or two) it takes only a short few moments for the water to reach any of the taps - works so well it... View more questions Search
|