Ask Experts Questions for FREE Help !
Ask
    sinnadurai's Avatar
    sinnadurai Posts: 127, Reputation: 2
    Junior Member
    		  
    #1

    Jan 23, 2011, 12:42 AM
    NEMA motors
    What is the relationship between Design code and other parameters like pf,efficiency,FLC, LRC, no load current etc?
    tkrussell's Avatar
    tkrussell Posts: 9,659, Reputation: 725
    Uber Member
    		  
    #2

    Jan 23, 2011, 07:15 AM

    The Design Code refers to the torque of the motor.

    See Design in the following Glossary:

    Reliance - Motor Glossary
    sinnadurai's Avatar
    sinnadurai Posts: 127, Reputation: 2
    Junior Member
    		  
    #3

    Jan 23, 2011, 08:04 AM
    Thanks for the information.But for only design code A,B,C&D load characteristics are given.For other codes is there any document to refer? Variation of pf,efficiency etc with design codes are not given.Thanks again.
    Is there a chart to select capacitors for PFC/starting of induction motors of different HP/SPEED?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Replacing a 220 volt plug for heater (appears from the chart to be an NEMA 2-30) [ 0 Answers ]

"I have an old (1970) electric drop-in (sub-floor) heater. This is a 220/30 volt heater with I believe 2 positive wires to it. The plug that goes into the receptacle on the finned heater is broken and should be replaced. I looked at the NEMA chart and a L2-30 appears correct but is no longer...

Can I wire a standard 250, 3 wire to nema type 1-30R receptical? [ 1 Answers ]

Purchased a LG LW2510ER window air conditioner for emergency conditions (ie.. main AC just died) the only 120/240 plug I know of in the house is the dryer plug. Trying to build an extension cord to run the dry power to this plug but not sure how to connect the 3 wires to each other. Air conditioner...

Comparison between single phase motors & three phase motors [ 3 Answers ]

Why single phase motors draws more current than three phase motors

Nema l14 20 plug [ 1 Answers ]

I have a generator that has a l14 20 plug and I want to run a 220v submersible pump.The pump has three wires, two hots and a ground.Is it okay to use it this way?

3 phase motors and single phase motors [ 4 Answers ]

Mike holt stated on one of his classes that in order for any eletrical equipment to work, that on one end had to be voltage and on the other side it had to have no voltage. So when the voltage goes to a three phase motor where does it go? Does it go to ground? I understand that the 3 phases are 120...

View more questions Search