 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
Check out some similar questions!
I have a 1989 Payne High Efficiency gas furnace (model 395CAV036075) that is no longer igniting/burning. When I opened the panel, I noticed what looks like pieces of a gasket sitting over and under the burners. It looks like it was originally about a 1/2 inch wide ring, very thin, and maybe 6...
My mother has a Payne Gas-Pac unit, model PY1P, ser # 0203G31100. It appears by what I am told that the blower motor is roaring and needs to be replaced. The unit was installed in Jan 2003, and she is being told that she should not waste her money on replacing this. She is on a limited income and I...
When trying to heat, the pilot is not igniting. It runs outside but blows cold air out of the vent. Not getting anything out of the vents inside. AC works fine. Could this be something simple that I could fix myself? Anything I could do to diagnose the problem?
Gas furnace is to draw combustion air from outside. Installation allows compution air to be feed into the furnace from the left or the right and provides a plug for the unused side. With the plug installed furnace tries to run but the pilot light gets blown out. Leaving the plug out the furnace...
I have a Payne Gas Furnace that works great until it is time for the blower to click on instead of coming on it clicks on and off once and a while it starts but only goes for a minute or two then goes back to clicking on and off can someone give me an idea of what this could be? Could my board be...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
