Ask Experts Questions for FREE Help !
Ask
    nonpocillovist's Avatar
    nonpocillovist Posts: 16, Reputation: 4
    New Member
    		  
    #1

    Jan 3, 2011, 01:32 AM
    Payne gas furnace
    I have a 1989 Payne High Efficiency gas furnace (model 395CAV036075) that is no longer igniting/burning.

    When I opened the panel, I noticed what looks like pieces of a gasket sitting over and under the burners. It looks like it was originally about a 1/2 inch wide ring, very thin, and maybe 6 to 8 inches in diameter, with little round protrusions along the outer edge about 4 inches apart.

    My questions:
    1. Could the failure of this gasket have caused the furnace to stop working?

    2. Can anyone direct me to a site that has a schematic/parts list for this furnace?

    3. Any suggestions/advice?

    Thank you.
    Julie

Check out some similar questions!

Payne furnace model 373LAV036070 won't ignite gas [ 1 Answers ]

I have a Payne 373LAV036070... I woke up to a cold house. I when through the process, turn power off, turn gas to off, wait 15min, and then flip breaker back on, turn gas knob to on and put doors back on. I heard and smelled gas but NO heat. The gas will not ignite. HELP

Payne Gas Pack Furnace Heater And A/C Unit [ 1 Answers ]

It's a Payne Gas Pack forced air furnace and A/C unit. At first the a/c functioned properly during the summer,now in winter the heat would'nt work. It's a unit that sit's on top of the roof in a apartment complex. First I thought it would be the tstat so I replaced it with a upgraded flux 400...

Payne gas furnace not getting enough [ 3 Answers ]

Gas furnace is to draw combustion air from outside. Installation allows compution air to be feed into the furnace from the left or the right and provides a plug for the unused side. With the plug installed furnace tries to run but the pilot light gets blown out. Leaving the plug out the furnace...

Repair or replace a Payne Gas Furnace? [ 2 Answers ]

G'day, I have a Payne PG8MAA042090 gas heater and I believe it's rated as 90,00 BTUs at 80%. This unit was installed in December 2002 due to t house inspection when I purchased the house. Shortly after that I installed a LUX1500 programmable thermostat from Home Depot and this combo has...

Payne Gas Furnace [ 1 Answers ]

I have a Payne Gas Furnace that works great until it is time for the blower to click on instead of coming on it clicks on and off once and a while it starts but only goes for a minute or two then goes back to clicking on and off can someone give me an idea of what this could be? Could my board be...

View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.