Ask Experts Questions for FREE Help !
Ask
    bruinbdog's Avatar
    bruinbdog Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Jan 18, 2011, 06:24 PM
    Keeping old bathroom six bulb lighting, but updating it?
    I want to keep the light, but does anyone have any ideas how to make it look better?
    Missouri Bound's Avatar
    Missouri Bound Posts: 1,532, Reputation: 94
    Ultra Member
    		  
    #2

    Jan 18, 2011, 08:25 PM
    Well... any chance you could send a picture? Hard to say what to do until you show us what you got. Anything can be cleaned, painted, polished... the globes (if there) can be changed... endless opportunity.
    bruinbdog's Avatar
    bruinbdog Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Jan 18, 2011, 11:55 PM
    I don't have a picture of my light, but here is a sample picture of what I'm dealing with. Want some ideas without having to change the fixture out. Thanks
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Upon installation of bulb, base of bulb burns and bulb never lights [ 1 Answers ]

Installed two new 3 bulb post lights on concrete entry piers, one bulb pops and burns the base immediately upon installation... I have checked the wiring and everything is wired correctly, I assume ths is a bad bulb socket and the fixture is defective, has anyone had this problem before?

Suggestions on what to replace recessed fluorescent bulb lighting with in kitchen [ 13 Answers ]

We have a 4'x6' diffuser panel grid with 3 four foot long fluorescent fixtures above and want to take it all out and update the look with either track lighting or can lights. The ceiling in the kitchen is a drop ceiling for the most part except the 4'x6' light panel portion which goes up 10 1/2"...

Hampton Track Lighting -- How to change the 50w bulb [ 0 Answers ]

The small bulb is impossible to remove. Do I remove the bulb only (not sure how since it won't come out) or is there more to changing a burnt out bulb than I realize w/Hampton tracking lights.

New lighting circuit run. I call it "The Bulb Killer". [ 15 Answers ]

Hey there everybody, I've run the lighting circuit and have been testing the light layout before I put the ceiling drywall up, but I've run into a problem that's going to put that on hold for a bit: I've got 6 cans, each with 75 watt PAR30L bulbs. They're controlled by two three way...

Bathroom lighting [ 1 Answers ]

Hi, I have a light fitting hanging precariously down from the roof middle of bathroom, where the worn earth wire is connected to some sort of steel collar, presumably earth. Other wires are fine. I want to replace the fitting. Questions; 1. what new wire do I need to buy, to act as earth...

View more questions Search