 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
Check out some similar questions!
I have a Trane xe80 furnace. Last night I noticed the blower wasn't shutting off. I reset the thermostat. The blower stays on and the burners ignite for 2 seconds and turn off. This repeats over and over. Can anyone help with this, as it is very cold in Missouri right now. Also the red light...
Trane XE80 No code flash means no power/control failure,what should I check first? Jumper wired at stat and control did not blow fuse. Ac works normally but when call to heat is sent fuse blows on control board.
Blower won't run, even in on mode, replaced stat, still nothing, has power to motor, can turn cage freely, furnace led light says system normal, compressor for air comes on, heat ignites, just no fan blower, any ideas
My 10 year old Trane XE80 in my woodworking shop lately cannot put out enough heat to satisfy the thermostat, which yesterday was set at 72 degrees on a 37 degree day. The steel building is completely insulated, and this has never happened before at this outside temperature. The furnace seems to...
My thermostat calls for heat, but the blower just comes on and blows air. No heat until I go down and manually restart the furnace. Any suggestions?
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
