 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
I have an XV90 Trane Furnace with a problem.
I have an XV90 Trane Furnace that will light the first burner but will not light the burners across to the heat sensor. It is doing this about 8 out of 10 tries and I have to turn the power off and back on to get it to try again. What would cause this?
I know this is not suggested but I can manually light the burners across to the heat sensor and get it to work for a while. |
||||
Check out some similar questions!
My XV90 upflow furnace gives a 9 red flash code when it starts up. My installers guide says it is an "Open Inducer Limit switcch". The furnace works OK, should I be worried about this?
Not sure what it is I think it says pressure switch problem> can this be fixed easy
Inside temp is 48 degrees, hard to type.. turned power off and waited and then turned back on with Trane VX90 furnace only 2 years old. Blower works but only cold air. Green light came on, it sounded like it was trying to work, then red light blinks three times (the portal glass you look...
Can you tell me if I can reliably replace the existing but faulty CNT 03777 integrated furnace control with the next version (CNT 04985), or should I spend twice as much on the current version (CNT 05160)? Thanks
I have a 2 year old Trane XV90 furnace. Here is my problem: Yesterday the AC was on while we were at work. The AC unit appears to be working fine but what I noticed is there was no air movement out of the ducts. I went down to check on the furnace blower only to find a puddle of water under my...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
