 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
I have a Bryant Plus 90 furnace model # 350MAV048060ABKA.
"I have a Bryant Plus 90 furnace model # 350MAV048060ABKA. The problem is for the last couple of years we had to reset it once or twice a day. Its giving me a 34/14 code, and I cleaned the flame sensor twice, green wire is attached to the chasis, ignitor works (glows), and normally it would start when i crank up the heat to 80 degrees. I took out the cover with the little glass; to see if it was dirty inside and its clean. Any ideas of what it could be???"
|
||||
Check out some similar questions!
I'm not getting any error led blips from the computer board. I can only see one limit switch which isn't tripped. I replaced the thermostat but that wasn't it. I've checked breakers and even tried tripping them off and then back on. Usually if I remember right this furnace goes through a...
Works fine most of the time. But sometimes I notice no heat is coming on and temperature spread could be 4 degrees from where it is set. Just doesn't come on. I go and check my breaker panel and breaker was not tripped but I reset anyway and furnace starts up and cycles fine. It could cycle proper...
No wiring diagram on panel door. Not having much luck retreiving one.
Bryant Furnace Mode No. 582ANW024060AAAD furnace after running for about 30 min. backfires and eventually the furnace will stop while the blower continuos to run. To be able to restart the furnace you have to turn off the breaker and furnace will backfire again before it will stop. >Moved from...
Hi, I recently had a furnace repairman in who told me our inducer on our Bryant Model 350MAV furnace needed to be replaced. He said the total cost would be $1075.00, including $890.00 for the inducer. This seemed high to me. Can anyone give me an idea of what this repair should have cost,...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
