 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Bryant model 383K downflow furnace
Works fine most of the time. But sometimes I notice no heat is coming on and temperature spread could be 4 degrees from where it is set. Just doesn't come on. I go and check my breaker panel and breaker was not tripped but I reset anyway and furnace starts up and cycles fine. It could cycle proper for hours. Then It may take place again and I need to go through the same procedure.
|
||||
Check out some similar questions!
Our Bryant 383K Gas Furnace starts and runs for few seconds and goes off. Than it starts again and the cycle continues. What is the problem and how can I correct it? E.R.
Are the bearings on the blower motor for a Bryant 383K furnace internally sealed, or can they be lubricated periodically? I disconnected power to my furnace and reached into the blower compartment to spin the fan and it seems to take a little bit of effort to get it to spin. Bad bearings? Replace...
My furnace burners cut on and off when calling for heat. The burner will first glow to light, than the burner will come on and five seconds later the burner will shut back off. It is almost like the furnace is short cycling. I did change the thermostat and the new thermostat is operating the unit...
Where is the exact location of the flamer sensor in a Bryant Model 383K Furnace? Is there a better diagram than I currently have in my user's manual? It is really for the installer. I know that I need to sand down/ steel wool the flame sensor, but can't remember the location. Thanks in...
12 yr old Bryant 383k upflow gas furnace. When first starting blowers run through three cycles then furnace locks out. Tried reseting Darft Safegaurd tube switch and Manual Reset Limit switch. Replaced filter. Have other gas appliances that work fine.
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
