 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Bryant 340AV error code 34 -
We have cleaned heat sensor and get the same code. In a previous post it was suggested that there may be a problem with the burner jet? Can you help? We are hitting below freezing temperatures tonight and do not want to wait until morning to call a service tech.
|
||||
Check out some similar questions!
Hello! I'm new on here so bear with me. I found a similuar post on the Bryant 80 but I believe I have a different model... not sure how much that matters. The only model number I could find on the unit was CK5AXA036017AAAA The Error code is 33 Limit or flame roll out switch is open. The furnace...
I have a Bryant 350MAV048100 furnace. It runs for 15 minutes, cycles off and then cycles on and shows an error code 31. I've cleaned out the intake /exhaust lines, but still have the problem.
Less then a year old. I'm getting an intermittent 42 error. After turning the power back on to the unit it goes through its self check mode and goes back to a constant light, indicating no problems. Then a day or two later 42 again. Both intake and exhaust pipes are clear, new air filter. Any...
I have the Bryant 352MAV 2-stage furnace that is giving me problems: When the thermostat is set below the target temperature i.e. 19C/68F the LED code indicator (on the logic board) is steady ON, once the target temperature is set i.e. 24C/78F , the inductor motor comes on for perhaps 15 sec, then...
Bryant Plus 80 furnace - Error code 31 What are the corrective measures to put this furnace back to producing heat? There is power, the fan works but there is no heat. We lost power recently but it worked after that. Last evening there were high winds which were indicated on the code...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
