 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Bryant 95 furnace with code 42 error
Less then a year old. I'm getting an intermittent 42 error. After turning the power back on to the unit it goes through its self check mode and goes back to a constant light, indicating no problems. Then a day or two later 42 again. Both intake and exhaust pipes are clear, new air filter. Any thoughts?
Thanks, Jason |
||||
Check out some similar questions!
I am getting error code 24 on my bryant furnace. Could someone please help me by letting me know what the code is, and how to fix it? I was trying to install a new thermostat and might have got wires crossed. Thanks
Hello! I'm new on here so bear with me. I found a similuar post on the Bryant 80 but I believe I have a different model... not sure how much that matters. The only model number I could find on the unit was CK5AXA036017AAAA The Error code is 33 Limit or flame roll out switch is open. The furnace...
I have a Bryant 350MAV048100 furnace. It runs for 15 minutes, cycles off and then cycles on and shows an error code 31. I've cleaned out the intake /exhaust lines, but still have the problem.
Bryant Plus 80 furnace - Error code 31 What are the corrective measures to put this furnace back to producing heat? There is power, the fan works but there is no heat. We lost power recently but it worked after that. Last evening there were high winds which were indicated on the code...
Hi, My 9-year-old Bryant 355MAV shut off after heating for about 15 minutes, even though the house is only about 60 degrees. I've been trying to figure it out all day. If I turn the furnace off, then back on, it will start up OK, the inducer motor starts running, the burners light up and the...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
