Bryant 80 Gas Furnace error 24

Damageddino Posts: 2, Reputation: 1

New Member

Nov 25, 2010, 08:55 AM

Bryant 80 Gas Furnace error 24

I was moving our thermostat, now heater is not working, LED blinks 2 times slow 4 times fast, panel says it's an open circuit at the 24 volt fuse, or a short. Could I have blown the fuse moving the thermostat? If so where is it located ? I'd like to try and do this myself,Being Thanksgiving, where can I get the Part? Home Depot?

Thanks
Happy Thanksgiving

Check out some similar questions!

Bryant furnace model 376cav, error code 24. [ 7 Answers ]

I am getting error code 24 on my bryant furnace. Could someone please help me by letting me know what the code is, and how to fix it? I was trying to install a new thermostat and might have got wires crossed. Thanks

Bryant furnace error code 31 [ 3 Answers ]

I have a Bryant 350MAV048100 furnace. It runs for 15 minutes, cycles off and then cycles on and shows an error code 31. I've cleaned out the intake /exhaust lines, but still have the problem.

Bryant 95 furnace with code 42 error [ 0 Answers ]

Less then a year old. I'm getting an intermittent 42 error. After turning the power back on to the unit it goes through its self check mode and goes back to a constant light, indicating no problems. Then a day or two later 42 again. Both intake and exhaust pipes are clear, new air filter. Any...

Bryant furnace won't start, error 42 [ 9 Answers ]

Hi all, I have a Bryant furnace, Plus 90i Evolution (355AAV060100) that won't start and gives error code 42 (checked by flashes and on service section on Infinity thermostat). The unit is mounted vertically in the basement, age unknown but thought to be only a couple of years. Was running fine...

Error codes on bryant gas pac [ 1 Answers ]

This is for Northernheat ----- you told me to clean my flame sensor and so I did and also cleaned the place that it is attached and put a ground wire from the screw to the ground screw on the board post to make sure and I still get a code of 8 flashes that said it detected an error in the soft or...

View more questions Search

Check out some similar questions!

Add your answer here.