Ask Experts Questions for FREE Help !
Ask
    kittyhead69's Avatar
    kittyhead69 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Nov 19, 2010, 10:05 AM
    Funace is 2 yrs. Old, a york gas
    The thermastat reads 65, I have it set at 70 and it won't come on unless I turn the thermastat off and then on.
    Joshdta's Avatar
    Joshdta Posts: 2,549, Reputation: 45
    Ultra Member
    		  
    #2

    Nov 20, 2010, 06:24 AM

    Look in the bottom door for a fault code light.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

York burners won't ignite mod P3HU 9 yrs. Old [ 3 Answers ]

When t-stat calls for heat the combustion blower starts, the glow plug glows but gas valve doesn't open and burn doesn't ignite. The combustion blower continues to run. Is this a problem with the pressure switch? Does it need to be replaced? :confused:

Gas funace/ac [ 2 Answers ]

Wiring schematic

Two thermostats one gas funace [ 3 Answers ]

I would like to use 2 thermostats on one gas furnace. One for the gas furnace and the other thermostat to control just the blower on same gas furnace? Then put in an out door wood boiler with hot water heat in same gas furnace. 4 wire heat cool. I have a Lennox G61MP series. Need to know how to...

Goodman gas funace pressure switch problem [ 9 Answers ]

I have a Goodman 93% efficient furnace that short cycles the gas burners. It cycles the vent on, starts the igniter, fires the burners and kicks on the blower but the burners only stay on for a short time ( less than 30 seconds). The led on the circuit board gives me 3 flashes indicating " pressure...

View more questions Search