Gas funace/ac

herb50 Posts: 2, Reputation: 1

New Member

Nov 5, 2008, 08:31 PM

Gas funace/ac

Wiring schematic

herb50 Posts: 2, Reputation: 1

New Member

Nov 5, 2008, 08:33 PM

Basic wiring schematic

MarkwithaK Posts: 955, Reputation: 107

Senior Member

Nov 5, 2008, 08:48 PM

Um for what?

Just saying it is a gas furnace tells us nothing.

Add your answer here.

Check out some similar questions!

Two thermostats one gas funace [ 3 Answers ]

I would like to use 2 thermostats on one gas furnace. One for the gas furnace and the other thermostat to control just the blower on same gas furnace? Then put in an out door wood boiler with hot water heat in same gas furnace. 4 wire heat cool. I have a Lennox G61MP series. Need to know how to...

Aircondition not running and funace not on [ 9 Answers ]

Hi All, I came home today and the I discovered the air conditioner is not working. The symptoms are that the furnace indicator lights are not on which might indicate the furnace is not getting power. The blower does not turn on when the thermostat is sending a signal. Also, the outdoor AC unit...

Current Limit for funace accessories [ 1 Answers ]

I've got an Air Ease furnace Mfg by Lennox. P/N G1D91Au. I've already connected a humidifier to the 120V HUM terminals on the blower control board. Also, I would like to add a couple of duct boost fans and wire to the blower control board. I could use the 120 V terminals for the Electronic Air...

Funace stops kicking on [ 3 Answers ]

Hi I am having problems with my furnace. It is a Pulse and is only about 7 or 8 years old. The problem is, is that it works for a while and then it will NOT kick on again. If you turn the power off at the thermostate it will come back on and will work again anywhere from 4 to 10 hours before it...

Goodman gas funace pressure switch problem [ 9 Answers ]

I have a Goodman 93% efficient furnace that short cycles the gas burners. It cycles the vent on, starts the igniter, fires the burners and kicks on the blower but the burners only stay on for a short time ( less than 30 seconds). The led on the circuit board gives me 3 flashes indicating " pressure...