Ask Experts Questions for FREE Help !
Ask
    tbug53's Avatar
    tbug53 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Nov 11, 2010, 07:10 PM
    Robert Shaw 9420 cannot set temp for the heater
    Just moved into a new house and it has the Robert Shaw 9420 system in place. During the warm month the AC worked perfect but since it has started turning cold(low 40's) at night I have been unable to set the temp for the heater. No matter what temp I set it the heater keeps running until I manually shut it down at 79, which means I either get up and down during the night to turn the system on/off or leave it off until I get up and turn it on to warm the house back up... how annoying is that?? Could anyone help me?
    Wigtail's Avatar
    Wigtail Posts: 7, Reputation: 1
    New Member
    		  
    #2

    Nov 11, 2010, 07:28 PM
    Sounds like the thermostat took a dump on the heater side. Probably lightning. Half of those wires if not all, run outside the house. A good reason to have your outside unit grounded.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Robert shaw thermostat eheat setting [ 1 Answers ]

We recently bought a home with a robert shaw 303 thermostat controlling our heat pump and air handler. We had a number of trades in doing some renos and I think they have adjusted the heat. I was leaving set as it was by the previous owner. My concern is that when I look at the display, I don't...

Questions about robert shaw 9620 thermostat [ 1 Answers ]

There are two temperatures being shown on the display screen of a Robertshaw 9620 thermostat. I know one of them is the room temperature (larger of the two) but what is the other temperature that is being shown?

Robert Shaw model #9420 flashing [ 1 Answers ]

Cannot get thermostat to do anything except turn on ?off the fan. Display is flashing. Pressing the light button does not even turn on light

Change out old thermostat with a Robert Shaw RS5110 [ 1 Answers ]

I currently have a General Controls T-90 thermostat and I want to switch that with a RobertShaw RS5110. My current Thermo is wired with a Green wire going to F a Black wirre going to C a White wire going to H and a Red wire going to M. There is no diagram for this configuation. Does anyone have...

View more questions Search