 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
Check out some similar questions!
I get three red flashes from the furnace after an attempt sequence when the t-stat calls for heat. The motor starts, and seems to try to light but after about thirty seconds, it quits and gives the error code. I have removed both gray tubes from the pressure switch and made sure they are...
Hi - we have a Trane XR80 and just tried to turn it on for the first time this year. The thermostat clicks on and the fan blows for a minute and then turns off. We removed the panel and a red light blinked three times, which, according to the trouble shooting codes means a pressure switch error. ...
I have a york furnace P2MD12H06401A after 1 hour it shuts down and gives a 2 flash error for a stuck pressure switch. The switch is new can it be wired wrong? The old one had 2 white wires piggy back and 1 blue wire. The new switch has 3 separate terminals
I have a york gas furnace. Condensation is leaking out of the exhaust motor. I removed the motor and everything seemed to be fine but when I put it back in and try to start the furnace, the red light flashes 3 times indicating pressure switch stuck open. What do I do now? I'm lost.
I have a York furnace and the blower is not coming on. The diagnostic fault code light started with 4 blinking reds which describes it as the limit swith is open. Now diagnostic fault code light is blinking 11 times which describes it as limit switch open - blower failure. I had the furnace off...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
